filename: tfs 115d.doc version 1.1 03.02.2006 vi telefilter filter specification tfs 115d 1/5 tele filter gmbh potsdamer stra?e 18 d 14 513 teltow / germany tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784-30 e-mail: tft@telefilter.com vi telefilter reserves the right to make changes to the produc t(s) and/or information contained herein without notice. no liab ility is assumed as a result of their use or application. no rights under any patent accompany the sale of any such product(s) or infor mation. measurement condition ambient temperature: 20 c input power level: 0 dbm terminating impedance: * input: 313 ? || -24 pf output: 268 ? || -29 pf characteristics remark: the reference level for the relative attenuation a rel of the tfs 115d is the minimum of the pass band attenuation a min . the minimum of the pass band attenuation a min is defined as the insertion loss a e . the centre frequency f c is the arithmetic mean value of t he upper and lower frequencies at the 1 db filter attenuation level relati ve to the insertion loss a e . the nominal frequency f n is fixed at 115,2 mhz without any tole rance. the given values for both the relative attenuation a rel and the group delay ripple have to be achieved at the frequencies given below even if the centre frequency f c is shifted due to the temperature coefficient of frequency tc f in the operating temperature range and due to a production tolerance for the centre frequency f c . d a t a typ. value tolerance / limit insertion loss a e 6 db max. 10 db (reference level) nominal frequency f n 115,2 mhz passband pb f n 1,92 mhz pass band ripple p-p 0,3 db max. 1 db relative attenuation a rel f n ... f n 1,92 mhz 2,5 db max. 3 db f n 4,2 mhz ... f n 7,5 mhz 35 db min. 25 db f n 7,5 mhz ... f n 12,5 mhz 48 db min. 35 db f n 12,5 mhz ... f n 25 mhz 60 db min. 38 db absolute group delay in pb p-p 0,75 s max. 0,85 s group delay ripple in pb p-p 100 ns max. 150 ns input power level ** max. 10 dbm operating temperature range otr -10 c..... +85 c storage temperature range -40 c..... +85 c temperature coefficient of frequency tc f *** -22 ppm/k - *) the terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understo od as reference values only. should there be additional questions do not hesitate to ask for an application note or contact our design team. **) maximum value for 10 years operation. ***) ? f c (hz) = tc f (ppm/k) x (t - t o ) x f to (mhz). generated: checked / approved:
filename: tfs 115d.doc version 1.1 03.02.2006 vi telefilter filter specification tfs 115d 2/5 tele filter gmbh potsdamer stra?e 18 d 14 513 teltow / germany tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784-30 e-mail: tft@telefilter.com vi telefilter reserves the right to make changes to the produc t(s) and/or information contained herein without notice. no liab ility is assumed as a result of their use or application. no rights under any patent accompany the sale of any such product(s) or infor mation. filter characteristic construction and pin connection (all dimensions in mm) date code 50 ohm test circuit s 115d u05 1 ground 2 ground 3 ground 4 output 5 output rf return 6 ground 7 ground 8 ground 9 input 10 input rf return date code: year + week u 2006 v 2007 w 2008 ... 70.2 79.2 88.2 97.2 106.2 115.2 124.2 133.2 142.2 151.2 160.2 -100 -90 -80 -70 -60 -50 -40 -30 -20 -10 0 frequency in mhz magnitude in db 112.2 112.8 113.4 114 114.6 115.2 115.8 116.4 117 117.6 118.2 -10 -9 -8 -7 -6 -5 -4 -3 -2 -1 0 frequency in mhz magnitude in db 112.2 112.8 113.4 114 114.6 115.2 115.8 116.4 117 117.6 118.2 0.57 0.69 0.81 0.93 1.05 1.17 1.29 1.41 1.53 1.65 1.77 frequency in mhz delay in s c1 l 1 saw l 2 c2 9 4 1, 2, 3, 6, 7, 8 5 10
filename: tfs 115d.doc version 1.1 03.02.2006 vi telefilter filter specification tfs 115d 3/5 tele filter gmbh potsdamer stra?e 18 d 14 513 teltow / germany tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784-30 e-mail: tft@telefilter.com vi telefilter reserves the right to make changes to the produc t(s) and/or information contained herein without notice. no liab ility is assumed as a result of their use or application. no rights under any patent accompany the sale of any such product(s) or infor mation. stability characteristics 1. high temperature (iec 60068 -3-1) 1,000 hours at +85c 2. low temperature (iec 60068 -3-1) 1,000 hours at ? 40c 3. humidity (iec 60068 -2-78) 1,000 hours at 85% /85c 4. thermal shock ( iec60068-2-14 ) -55 c to 125c / 30 min. each / 10 cycles 5. vibration (iec 60068 -2-6) 10 hz to 500 hz, 0,35 mm or 5g respectively, 1 octave per min, 10 cycles per plan, 3 plans 6. shock (iec 60068 -2-27) 500g, 1 ms, half sine wave, 3 shocks each plane 7. reflow profile ( defined at specification ) 260c +/- 5c for 10 seconds, 2 cycles 8. solerability 235c +/- 5c for 15 seconds, 1 cycle 9. pullability, distortion according to mil-std 883 method 2004.5 condition d this filter is rohs compliant (2002/95/eg, 2005/618/eg) packing tape & reel: iec 286 ? 3, with exeption of value for n and minimum bending radius; tape type ii, embossed carrier tape with top cover tape on the upper side; max. pieces of filters per reel: 3000 reel of empty components at start: min. 300 mm reel of empty components at start including leader: min. 500 mm trailer: min. 300 mm g do w ct f e g d1 p2 p1 po bo ao pull off direction pin marker typ date code ko t a c n w 1 w 2 the minimum bending radius is 45 mm. tape (all dimensions in mm) w : 16,00 0,3 po : 4,00 0,1 do : 1,50 +0,1/-0 e : 1,75 0,1 f : 7,50 0,1 g(min) : 0,60 p2 : 2,00 0,1 p1 : 8,00 0,1 d1(min) : 1,50 a o : 5,50 0,1 bo : 7,50 0,1 ct : 13,5 0,1 reel (all dimensions in mm) a : 330 w1 : 16,4 +2/-0 w2(max) : 22,4 n(min) : 50 c : 13,0 +0,5/-0,2
filename: tfs 115d.doc version 1.1 03.02.2006 vi telefilter filter specification tfs 115d 4/5 tele filter gmbh potsdamer stra?e 18 d 14 513 teltow / germany tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784-30 e-mail: tft@telefilter.com vi telefilter reserves the right to make changes to the produc t(s) and/or information contained herein without notice. no liab ility is assumed as a result of their use or application. no rights under any patent accompany the sale of any such product(s) or infor mation. air reflow temperature conditions conditions exposure average ramp-up rate (30c to 217c) less than 3c/second > 100c between 300 and 600 seconds > 150c between 240 and 500 seconds > 217c between 30 and 150 seconds peak temperature max. 260c time within 5c of actual peak temperature between 10 and 30 seconds cool-down rate (peak to 50c) less than 6c/second time from 30c to peak temperature no greater than 300 seconds temperature / c time / s max. 260c 217c 10 ... 30 s 30 ... 150 s max. 300 s chip-mount air reflow profile
filename: tfs 115d.doc version 1.1 03.02.2006 vi telefilter filter specification tfs 115d 5/5 tele filter gmbh potsdamer stra?e 18 d 14 513 teltow / germany tel: (+49) 3328 4784-0 / fax: (+49) 3328 4784-30 e-mail: tft@telefilter.com vi telefilter reserves the right to make changes to the produc t(s) and/or information contained herein without notice. no liab ility is assumed as a result of their use or application. no rights under any patent accompany the sale of any such product(s) or infor mation. history : version reason of changes name date 1.0 generate development specification chilla 21.06.2005 1.1 generate filter specification chilla 03.02.2006 terminating impedances added typical values added filter characteristics added test circuit added rohs compliance added
|
